LCA series
+
Capacitance 5%, 105C
-
<
lowest E.S.R.( 0.0016 OHM)
=
Strong finishing for a better installation result
1 pair of clear brackets included
Chrome plated post kits
PDF created with pdfFactory Pro trial version www.pdffactory.com
the capacitor must bi discharged
when the capacitor is removed form
the system. place the same bulb
which was used in charging across
the terminals of the capacitor to
eliminate the stored power. The
capacitor will bi fully discharged
within a few seconds noted by the
The supplied charging bulb(included
in the package)is used when initially
charging the Cap. the charging process
is accomplished by connecting the
charging bulb in series between the
battery’s positive post and the
capacitor’s positive terminal.(plese
refer to the diagram below). it is very
important to follow this process to
eliminate the possibility of damaging
the cap/battery, and other audio
devices. The charging process is
complete when the voltage of the
capacitor reaches the same voltage
as your vehicle’s battery. This process
will take a matter of seconds to
bulb going out. It is now safe to
store your a capacitor.
complete. You can use a voltage meter
to check the voltage across your
battery and cup .when the voltages
are the same on both(cap and battery),
the cap has been fully charged. The
charging bulb actually eliminates the
need for the volt meter, when the cap
is fully charged (cap and battery have
same voltage) the bulb will go either
dim or fully out.
1 year (except in the event the vent
is blown or leaking due to reversed
polarity or the cap has stripped
screws or terminals)
MODEL
CAPACITANCE VOLTAGE DIMENSION
1.2Farad
2.4Farad
1.6Farad
2.8Farad
5.0Farad
20~24V
20~24V
16~20V
16~20V
16~20V
Dia. 3.0 x h. 8.86
Dia. 3.5 x h. 8.86
Dia. 3.0 x h. 8.86
Dia. 3.5 x h. 8.86
Dia. 3.5 x h. 8.86
LCA-120DBL
LCA-240DBL
LCA-160SL
LCA-280SL
LCA-500SL
PDF created with pdfFactory Pro trial version www.pdffactory.com
|