INSTALLATION INSTRUCTIONS FOR PART 99-7009
APPLICATIONS
Mitsubishi Endeavor
2004-2010
99-7009
KIT FEATURES
s DIN Head Unit Provisions
s ISO DIN Head Unit Provisions
KIT COMPONENTS
A) Radio Housing
s
B) ISO Brackets
s
C) Trim Plate
C
A
B
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
s ꢀꢁꢂꢀꢁꢁꢃ ꢂ -ITSUBISHI HARNESS ꢃꢄꢄꢅꢂUP
s -)4/ꢂꢁꢃ ꢂ -ITSUBISHI AMPLIFIED )NTERFACE ꢅꢁꢁꢆꢂUP
Antenna Adapter:
s .OT REQUIRED
OOLS REQUIRED:
T
Phillips Screwdriver s Socket Wrench
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
99-7009
2004-2010 MITSUBISHI ENDEAVOR
A
Disconnect the negative battery terminal
to prevent an accidental short circuit.
1
2
Unsnap and remove entire panel sur-
rounding radio and A/C controls.
(Figure A)
3
Remove (1) 10MM nut from the rear support
on the top left of radio on cross bar behind
dash. (FIGURE B)
B
4
5
Remove (3) Phillips screws to remove
factory radio chassis (Figure C)
Remove (4) Phillips screws from the pock-
et at the bottom of the radio and A/C panel
and remove the pocket. (This is where the
C
99-7009 will be mounted.) (Figure D)
D
1
..",%%.
9>Cꢀ=ZVYꢀJc^iꢀEgdk^h^dc
5SING THE FACTORY HARDWAREꢂ MOUNT
THE ꢃꢃꢁꢄꢅꢅꢃ IN THE LOCATION WHERE
THE FACTORY POCKET RESIDEDꢀ
3LIDE THE $). CAGE INTO THE 2ADIO
(OUSING AND SECURE BY BENDING
THE METAL LOCKING TABS DOWNꢀ
ꢀ
ꢁ
3LIDE THE AFTERꢁMARKET HEAD UNIT
INTO THE CAGE AND SECUREꢀ 3NAP
TRIM PLATE INTO THE RADIO HOUSINGꢀ
'
..",%%.
>HDꢀ9>Cꢀ=:69ꢀJC>IꢀEGDK>H>DC
-OUNT THE )3/ "RACKETS TO THE HEAD
UNIT WITH THE SCREWS SUPPLIED WITH
THE UNITꢀ
ꢀ
3LIDE THE HEAD UNIT INTO THE RADIO
OPENING UNTIL THE SIDE CLIPS ENGAGEꢀ
ꢁ
ꢂ
3NAP THE 4RIM PLATE INTO THE 2ADIO
(OUSINGꢀ
(
..",%%.
!
"
!
"
#
$
3TRIP WIRE ENDS BACK ꢄꢇꢀꢈ
4WIST ENDS TOGETHER
3OLDER
#
$
4APE
,OCATE THE FACTORY WIRING HARNESS IN THE DASHꢀ
-ETRA RECOMMENDS USING THE PROPER MATING
ADAPTER AND MAKING THE CONNECTIONS AS
SHOWNꢀ ꢆ)SOLATE AND INDIVIDUALLY TAPE OFF THE
ENDS OF ANY UNUSED WIRES TO PREVENT ELECTRICAL
SHORT CIRCUIT 3EE FIGURE !ꢀ
ꢀ
ꢁ
ꢂ
2EꢁCONNECT THE NEGATIVE BATTERY TERMINAL AND TEST
THE UNIT FOR PROPER OPERATIONꢀ
2EASSEMBLE RADIO AND DASH ASSEMBLIES IN
REVERSE ORDER OF DISASSEMBLYꢀ
)
..",%%.
*
INST997009
1-800-221-0932
Rev. 04-26-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7009
|