E X E C U T I V E
I C E M A S T E R I C E M A K E R
PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 y e a r g u a r a n t e e
MW_ICM001A_IM.indd
1
2012/09/04 11:37:20 AM
PREPARING YOUR ICE MAKER FOR USE
When using electrical appliances, basic safety
precautions should be followed to reduce the risk
of fire, electric shock, and injury to persons or
property. Read all instructions before using any
appliance.
- Children should be supervised to ensure that
they do not play with the appliance.
- Use the appliance in a well ventilated area.
- Do not place the appliance on hot surfaces,
such as cooking plates, gas burners, ovens
or similar.
SAFETY ADVICE:
CAUTION: In order to prevent overheating do not
- Do not operate this appliance with a damaged
power cord. If the power cord is damaged,
it must be replaced by the manufacturer or its
service agent or a similarly qualified person in
order to avoid a hazard.
cover the appliance.
- Do not use the appliance if it has fallen on the
floor, if there are visible signs of damage or if it
has a leak.
- Ensure that the voltage on the rating label
corresponds with the voltage of the wall socket.
No other appliance should be plugged into
the same wall socket when using this appliance.
Ensure that the plug is fully inserted into the wall.
- Do not allow the power cord to come into contact
with hot, rough or sharp surfaces and objects.
- Do not allow the power cord to hang over the
edge of the counter.
- Do not pull on the power cord to remove the
plug from the wall socket. Do not use the power
cord to lift, pull or carry the appliance.
- Always use the appliance on an even surface.
- Do not touch the plug, power cord or appliance
with wet hands.
- Do not submerge the plug, power cord or
appliance in water or any other liquid.
- Only use this appliance for its intended purpose.
- Only use the accessories provided with this
appliance. Using other accessories can cause
the appliance to malfunction.
- Do not use this appliance with plug adaptors
and extension cords.
- Switch off the appliance & remove the plug from
the wall socket before undertaking any cleaning
task or when the appliance is not in use.
- This appliance is intended for household use
only. Do not use the appliance outdoors.
- Do not place this product in direct sunlight.
- Ensure that there is a 10cm gap between the
unit and surrounding objects.
- Do not use any other liquids to make ice-cubes
other than clean water.
- Do not clean your ice maker with flammable
or hazardous fluids. The fumes can create a fire
hazard or an explosion and could be hazardous
to your health.
- Do not touch the evaporator while the appliance
is in use.
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER:
1. Remove the exterior and interior packaging.
Check if ice basket and ice scoop are inside.
If any parts are missing, please contact our
customer service department.
2. Remove the tape securing the ice shovel, ice
basket & ice scoop in place. Clean the tank &
ice basket.
- Do not tilt or turn the appliance over. This
appliance should remain upright at all times.
- This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance and are supervised during
use of the appliance by a person responsible
for their safety.
3. Put the ice maker on a level counter top away
from direct sunlight or any other sources of heat.
4. Ensure that the unit has a 10cm space on all
sides from surrounding objects.
5. Allow the water to circulate through the
product until it indicates “ADD WATER”.
6. Empty all water and refill the product with fresh
clean water.
7. Only use cold water when using this product.
8. To get larger, more dense ice bullets, use
MW_ICM001A_IM.indd
3
2012/09/04 11:37:23 AM
cover, remove the ice basket and pour water
into the tank. Keep water level below the
“MAX” water level mark.
refrigerated cold water.
WARNING: fill with fresh clean water only.
2. Press the “ON/OFF” button on the control
panel to begin the ice making cycle.
CONNECTING YOUR ICE MAKER:
3. Select the ice cube size by pressing the
“SELECT” button. If the room temperature is
lower than 15 C, it is recommended that the
small ice cube setting is selected in order to
avoid ice bullets sticking together.
4. The ice making cycles last approximately 6
to 13 minutes, depending on selection of ice
cube size and the room temperature. The room
temperature should be between 10 C to 35 C
when making ice.
*If the plug, power cord or appliance is damaged
in any way, please return the unit to the
manufacturer or their designated service agents
to avoid the risk of electric shock or injury.
1. This unit should only be used in a single
standard wall socket. Ensure that the plug fits
securely and correctly into the wall socket. Do
not try to alter or change the plug as this could
be dangerous and will render the warranty null
& void.
5. If the water pump can’t supply water to the
ice making box, the ice maker will stop
automatically, and the “Add Water” indicator
will illuminate. Press the “ON/OFF” button
to switch the unit off then fill water up to the
maximum water level mark and press “ON/OFF”
button again to switch the unit on.
6. The unit stops when the ice basket is full and
the “Ice Full” indicator is illuminated. Remove
the ice bullets and replace the empty ice
basket to continue making ice.
WARNING: Direct sunlight or sunlight reflection
may cause the infrared sensor to malfunction.
If the unit doesn’t stop when the ice cubes
obstruct sensor, please contact the customer care
department and seek advice.
2. This appliance requires a wall socket that is
capable of a supply of 220-240V, 50Hz.
CLEANING & MAINTAINING YOUR ICE MAKER:
Beforeusingyouricemaker,cleantheappliance
thoroughly as explained in “OPERATING
PROCEDURES & MAINTENANCE”.
1. Take out the ice basket.
2. Clean the removable ice basket & ice shovel
with diluted detergent, warm water and a soft
cloth. Then rinse with clean warm water.
3. Use clean water to rinse the inside parts, and
drain out the water by removing the water drain
cap on the right front bottom corner of the base.
Ensure to pour the water out into a sink/basin
and dispose of the water correctly.
7. Change the water in the water reservoir every
24 hours to ensure a safe hygiene level.
4. The outside of the ice maker should be cleaned
regularly with a mild detergent solution and
warm damp cloth. Rinse with a clean damp
cloth.
5. Clean the water tank with water and a mild
detergent using a soft damp cloth, then
rinse with a clean soft damp cloth.
6. Dry the interior and exterior with a clean soft cloth.
7. When the product is no longer required for
regular use, drain all water & dry the interior.
USING YOUR ICE MAKER:
1. Clean the unit following the instructions under
the “Cleaning and maintaining your ice maker”
section of this instruction manual. Open the
MW_ICM001A_IM.indd
4
2012/09/04 11:37:23 AM
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
“Add Water”
indicator is on.
Switch off the ice maker, fill water, and
press “ON/OFF” button again to restart
the unit.
Little water in water
reservoir.
“Ice Full” indicator
is on.
Remove ice from ice basket. Replace the
empty ice basket immediately to prevent
the next batch ice bullets from falling
into the water reservoir.
The ice basket is full.
Ice cubes stick
together.
Stop the ice maker, and restart it when the
ice blocks melt. Select the small size ice
cube selection.
The ice making cycle is too
long.
Replace the water. Temperature of water
recommended at 8-22 C.
Water temperature in inner
tank is too low.
Ice making cycle is
normal but no ice
formed.
The room temperature should be 10-35 C,
water temperature should be 8-22 C.
Room or water temperature
in inner tank is too high.
Return product to service center to be
verified by a qualified technician.
Refrigerant in cooling
system may be leaking.
Return product to service center to be
verified by a qualified technician.
Pipe in the cooling system
could be blocked.
WARRANTY INFORMATION
The warranty will not apply in cases of:
- Normal wear and tear.
WARNING: Keep the ventilation opening of the
appliance clear of obstructions and a minimum
space of 10cm from surrounding walls and
surfaces.
- Incorrect use, e.g. overloading the appliance,
use of different accessories.
- Use of force, damage caused by abuse and
neglect.
WARNING: Do not damage the refrigerant circuit.
- Damage caused by not following instructions as
set out in this instruction manual.
- Partially or completely dismantled appliances.
- The warranty only covers defects in material or
regular and proper use of the appliance.
- The repairs under warranty may only be carried
out by an authorized service centre. When
making a claim under the warranty, the original
proof of purchase (with purchase date) must be
submitted.
The warranty will be rendered null & void if the
appliance shows any signs of abuse, neglect,
incorrect use of the appliance or any attempt to
dismantle or repair the appliance.
MW_ICM001A_IM.indd
5
2012/09/04 11:37:23 AM
MW_ICM001A_IM.indd
6
2012/09/04 11:37:24 AM
|