Config ure the Route r
2
®
A Division of Cisco Systems, Inc.
D
E
If you have a second phone
line, repeat step C to connect
a telephone or fax machine to
the Router’s PHONE 2 port.
There are two ways to configure the Router. Choose one of the following:
In Step 2, you will need the setup
instructions provided by your Internet
Service Provider (ISP). If you do not
have this information, then contact
your ISP before proceeding.
• Run the Setup CD-ROM - It is strongly recommended that you use the
Setup CD-ROM. Insert the Setup CD-ROM into the CD-ROM drive, and
follow the on-screen instructions.
Connect your cable or DSL
modem’s Ethernet cable to
the Router’s Internet port. (If
your modem only provides a
USB output, then you will need
to upgrade your modem.)
The instructions from your ISP tell you
how to set up your PC for Internet
access. Because you are now using
the Router to share Internet access
among several computers, you will
use the setup information to
configure the Router instead of
your PC.
•Use this Quick Installation guide - If you wish, you can use the Router’s
Web-based Utility. Proceed to Step 1 of this Quick Installation.
NOTE: Make sure your PC’s
Ethernet adapter is set to obtain
an IP address automatically. For
more information, refer to
Windows Help.
E
Conne c t the Route r
1
F
Power on the cable or DSL
modem.
A
Make sure that all of your
hardware is powered off,
including the Router, PCs, and
cable or DSL modem.
G Connect the included power
adapter to the Router’s Power
port, and then plug the power
adapter into an electrical
outlet.
A
Open your PC’s web browser.
Router’s default local IP
address) in the web browser’s
Address field. Then press the
Enter key.
G
A
B
Connect one end of an
Ethernet network cable to one
of the numbered ports on the
back of the Router. Connect
the other end to an Ethernet
port on a network device, e.g.,
a PC, print server, or switch.
The Power LED on the front
panel will light up as soon as
the power adapter is
B
A screen will appear and ask
you for a User Name and
Password. Enter admin (the
default) in the User Name and
Password fields. (Later you
should set a new password
using the Administration tab’s
Management screen. This will
help secure access to the
Web-based Utility.)
connected properly.
B
Package Contents
H
Power on the PC you wish to
use to configure the Router.
• Broadband Router with 2 Phone Ports
• Power Adapter
• Setup Wizard CD-ROM with Norton Internet Security
• Installation and Troubleshooting Guide
• Network Cable
Repeat this step to connect
more PCs or other network
devices to the Router.
B
• Telephone Jack Adapter
• Quick Installation
C If necessary, disconnect the
telephone cable from the
telephone wall jack and
Then click the OK button.
connect that end to the
telephone jack adapter. Then
connect the adapter to the
Router’s PHONE 1 port.
Broadband Router
C
with 2 Phone Ports
NOTE: Make sure your telephone
is set to its tone setting (not
pulse).
Quick Installation
VoIP
VoIP
Model No.
RT31P2-VU
|