Lytecaster® Recessed Downlighting 1100AICMFT
Page 1 of 1 6 3/4”Aperture Fluorescent 1 Lt. 26/32W Triple Tube Insulated Ceiling, AirSeal® Frame-In Kit
1
6
Overall width: 9”
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit
Reflector Trims — See Individual Reflector Trim Specification Sheets
Open Downlight
Wattage & Lamp Type
Wall
Washer
Enclosed
Diffusers
Alzak®
Satin
Cone
Baffles
Basic
White
1100AICMFT
Cone:
1112
1113
1108
1110
1105
1105WH
1176
Cone:
1113WH
Reflector:
26W - 32W
PL-T by Philips
DULUX by Osram Sylvania
Triple BIAX by GE
1113BK
1176WH
Reflector:
1143
1144
Reflector:
1170M1
1171
1121
1124
1134
1177SH
1178SH
26W
1185
1186
1186WH
PL-T by Philips
DULUX by Osram Sylvania
Triple BIAX by GE
1126
1128
26W
PL-T by Philips
Features
Options & Accessories
Mounting Bars:
Concealed Spline Ceiling Kit:
1. Housing: .026” galvanized steel. UL listed for direct contact with thermal
insulation. AirSeal® housing minimizes air leakage to less than 2 CFM at
1.57 PSF, which complies with Model Energy Code (Section 602.3.3) and the
Washington State Energy Code (Section 502.4) and reduces heat loss and
condensation in ceiling. Access door for inspection of junction box.
2. Mounting Frame: .036 (#20 ga.) galvanized steel. Accommodates all ceil-
ings up to 1” thick. 3/8” deep integral lip. Four slots are positioned 90°
apart to simplify alignment. Push-in/twist-out rotoclips hold reflector flush
to ceiling.
1976 - 13” set of (4).
1965 - set of (4), 1 1/2“ to 2” Mtg. Ht.
Extra-Thick Ceiling Mounting Ring: 1967A - up to 2” thick ceiling.
Labels
UL Type I.C. (Suitable for Damp Locations);
Complies with Air Leakage Requirements as stated in the Model Energy Code
and the Washington State Energy Code.
AirSeal® is a registered trademark of Lightolier.
Romex® is a registered trademark of General Cable Industries Inc.
US Patent Nos. 4,313,154; 5,045,985
3. Junction Box: 2” X 4” X 4”: .063” (#14 ga.) galvanized steel. UL listed for
maximum of 6 No. 12 ga., 90° C through branch circuit conductors. Quick
release “L” shaped cover for outside access to wiring. Access door inside of
housing allows easy inspection of wiring without removal of housing.
Integral cable clamps permit attachment of nonmetallic Romex® or armored
without the need for additional connectors.
4. Mounting Bars: .059” (#16 ga.) galvanized steel. Bars pivot for easy
attachment and wire-in below ceiling line. Bars extend to accommodate 16”
to 24” O. C. joist spacing and feature integral nail for secure attachment to
wood construction. Attaches to T-bar ceilings without the need of acces-
sories.
Job Information
Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
5. Ballast: Electronic, encased and potted, thermally protected, Class “P”,
Normal Power Factor, 120V.
6. Socket: 4-pin Gx24q-3 base compact fluorescent. Pre-wired with #18 ga.
TFN leads to junction box.
Lightolier a Genlyte Thomas Company
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2002 Genlyte Thomas Group LLC (Lightolier Division) • A0902
|