Precision Cooling
For Business-Critical Continuity™
Back-of-Rack Cooling Module
Liebert XDR-W Rack Cooling Module
Flexibility:
The Liebert XDR-W cooling modules are attached to the back of your selected
racks, drawing hot air from the rack and cooling it to the point where the impact
on the room is close to neutral, then discharging it back into the room. These
modules are connected to a Liebert XDP-W coolant pumping unit, which acts as
an isolating heat exchanger between the building chilled water source and the
circulating cooling water.
Installs and configures easily
Allows scalability for
future growth.
Provides flexible configuration to
eliminate hot spots.
Higher Availability:
Provides built-in redundancy:
A dual pump in the coolant
distribution unit will keep the
fluid flowing; if a fan in the
cooling module shuts down,
the others keep running.
The pumping unit maintains the
coolant to the XDW-R at a
temperature always above the
actual dewpoint, to prevent
condensation.
The modular and adaptive design of the Liebert XDR-W unit also allows it to be
easily added as the demand for cooling increases.
Lowest Total
Cost of Ownership:
Operates with the energy-efficient
Liebert XDP-W coolant pumping
unit, which can support up to 12
XDR-W modules.
Saves energy by cooling at
the heat source.
Ideally Suited For:
Applications where a hot aisle/cold
aisle approach is not practical.
|